FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
Configuration | en
77
Bosch Sicherheitssysteme GmbH
User Guide
2020-07 | 3.0 | F.01U.378.877
2.
Select the element category you require.
3.
Select one or more list fields.
The list fields are marked.
4.
Select
Add
.
The selected element is added to the selected walktest group.
Refer to
–
Scrolling through lists, page 25
18.3.2
Change name
To change the name of the input or output group:
1.
Overwrite the name
2.
Select
OK
.
The new name is confirmed.
18.4
Detector sensitivity
!
Caution!
Detector sensitivity is automatically reset to the default setting
When the entire panel or the individual detector/logical zone is reset
When the detector is replaced
Two different sensitivities can be assigned to detectors and logical zones in the FSP-5000-RPS
programming software — a default setting and an alternative setting.
It is possible to switch between the default and alternative setting on the panel controller.
To change the setting:
1.
In the start menu, select
Configuration
2.
Detector sensitivity
Various lists are offered. Select one of the detector or logical zone lists that are offered.
A list of elements is displayed. Depending on the list you have selected, enter the number
or the name of the element into the search screen.
3.
Select the list field you require, e.g. a logical zone in this case.
Two settings are displayed: There is a checkmark in the selection field in front of the
active setting.
4.
Select the selection field of the detector sensitivity you require.
A checkmark is set in this field.
5.
Select
OK
to confirm the selection or
Cancel
to cancel the operation.
The selected detector sensitivity is confirmed for the detector.
18.5
Operator
Depending on whether the same password is used per access level, or whether each user has
a different password, one of the following two options is offered:
If the same password is used per access level:
–
Change universal password
: The same password can be configured for each access level
in the FSP-5000-RPS programming software. This means that all operators with access
authorization for the second level receive the same password, for example. The password
for access levels two to four can be changed.
If each user uses a different password:
–
Change operator data
: Change the password for an operator.
–
Set default password
: Reset a user password to the following number sequence: 000000.
