Bosch AUTODOME 5000, Operation Manual

Page: 43 / 74

TOUR
Run Tour Enter
Exit YES
Tour
Up to eight sets of Tour routes can be created for one camera. Use the LEFT/RIGHT direction
keys to select a set first and then follow the steps below to start recording the Tour route.
Record Start
Follow the description below to record the TOUR route.
1.
Rotate the camera to a desired view area (for some protocols, you may need to do it
before entering the OSD), and press <CAMERA MENU> to build the tour path using the
joystick on the control device. The percentage of the memory buffer used will be
displayed on the screen.
2. Pan, tilt and zoom the camera to form a path.
Notice!
Beware of the memory size when building a Tour route. Once the buffer percentage reaches
100%, recording stops.
Record End
The cursor moves to RECORD END while building the Tour route. When the setting is
completed, press <CAMERA MENU> to save the route.
Run Tour
Press the <CAMERA MENU> key (ENTER) to run the defined Tour path after tour setting is
complete.
Notice!
You can execute the Tour function through a control keyboard. Refer to the control
keyboard’s quick guide for further information.
Preset Tour
This function executes pre-positioning of the pan, tilt, zoom and focus features in a certain
preset tour for a camera. Before setting this function, you must pre-define at least two preset
points.
PRESET TOUR
P. Tour 01
P. Tour Point 01
Preset Pos. 01
Speed 01
Dwell Time 000 Sec.
Run P. Tour Enter
Exit YES
Preset Tour
There are eight sets of preset tour built in the camera. Use the LEFT/RIGHT direction keys to
select a set first and then set its preset tour points.
6.12.3
AUTODOME 5000 Analog PTZ Camera On-Screen Display (OSD) Menu | en 43
Bosch Security Systems, Inc. Operations Manual 2013.07 | 1.3 |