Bosch AUTODOME 5000, Operation Manual

Page: 48 / 74

Mode Line
After you select a schedule function for MODE, you can specify the MODE LINE of the selected
schedule function. According to different schedule functions, options for MODE LINE will be
different.
Schedule Reset
You can reset the whole schedule setting with this item.
Misc. Function
You can set up some miscellaneous functions here.
MISC FUNCTION
Angle Adjuster Enter
PT Position Enter
Speed By Zoom Off
Auto Cali. Off
Exit YES
Angle Adjuster
You can adjust the range of tilt motion by defining the angles between which the camera tilts.
The minimum range is from −10° to 10°. The maximum range is from 80° to 100°. The default
tilt angle is 90°.
PT Position
PT Position can setup the display of the Pan/Tilt position of the camera on the screen. Refer
to section Monitor Display, page 33 for the displaying location.
–
PT Display
Set this item to <ON> to enable the display of the pan/tilt position on the screen. The
display format will be “XX YYY/ YY”.
– Set Pan Zero
By using <SET PAN ZERO> function, you can set the North as coordinate zero.
The display will show eight different directions including N, E, S, W, NE, SE, SW and SN,
depending on the closest direction that the camera is facing. The PAN range is from 0° to
359°, and the TILT range is from 10° to −90°. Once the TILT degree is lower than −90°,
the PAN degree will automatically be added 180°.
Speed By Zoom
If this item is set to <ON>, the pan/tilt speed will be adjusted automatically by internal
algorithm when zooming. The larger zoom ratio leads to the lower rotating speed.
Auto Cali. (Auto Calibration)
Each camera has one horizontal point and one vertical infrared rays check point. During
installation or maintenance, the camera’s position may be moved. Therefore, the relative
distance between the original set point and the check point will be changed. If the Auto
Calibration function is enabled, the camera will automatically detect the matter and reset the
horizontal point back to the original position.
Display Setup
The Display Setup menu is as shown below:
6.12.8
6.13
48 en | On-Screen Display (OSD) Menu AUTODOME 5000 Analog PTZ Camera
2013.07 | 1.3 | Operations Manual Bosch Security Systems, Inc.