Bosch AUTODOME 5000, Operation Manual

Page: 60 / 74

Notice!
To make the camera tilt between a specific range (−10° to 100°), refer to the section Angle
Adjuster to set the angle range of tilt movement. Otherwise, the camera will tilt 90° as the
default setting.
OSD Auto Close
Specifies the duration that the OSD menu appears on the screen, in seconds: 10, 15, 20, 25,
30, 60, 90, and 120.
To keep the OSD menu on the screen without auto exit, set this option to <OFF>.
Camera Setting
Camera ID Setup is where installers can set up camera ID-related parameters, which are as
follows.
CAMERA SETUP
ID Setting
ID Info.
Restore Defaults
Exit YES
ID Setting
Sets up the camera ID.
ID SETTING
Setting Type OSD
ID Number. 001
Title Setting Enter
Protocol OSRD
Baud Rate 9600 BPS
Exit YES
– Setting Type
Select the setting type for the camera ID. Options are: OSD (for setting the ID using the
OSD),
HW (for setting the ID using the DIP switch).
Set the OSD as the first priority. If installers set the camera ID by using the DIP switch,
then they must still enter the OSD menu to select “HW” (Hardware setting) before the
DIP switch will work. If installers do not select “HW” (Hardware setting), then the camera
uses the OSD setting automatically.
– ID Number
Select the ID number. The default is 001.
– Title Setting
Set up the title for the camera.
– Protocol
Select OSRD, Pelco D, Pelco P.
– Baud Rate
6.16.2
60 en | On-Screen Display (OSD) Menu AUTODOME 5000 Analog PTZ Camera
2013.07 | 1.3 | Operations Manual Bosch Security Systems, Inc.