Bort 93410976, Manual

Page: 7 / 30

7
• If necessary, put on a brush (9) or fabric nozzle (10) .
• Connect the steamer to the power network . The heating
indicator lights up in blue . Heating will start automatically
after 10 seconds (the indicator lights steadily in red) . In less
than 30 seconds, the steamer will be ready for use .
• To supply steam, press the steam button (3) .
• For lock the button in the pressed state, push down the
lock lever on the button (2) .
When you turn on the steam supply, a steady supply is not
established immediately, but after 10-60 seconds (depends
on the degree of heating of the steamer) . During heating, a
small amount of water droplets may exit the nozzles along
with steam . For this reason, do not direct the steamer di-
rectly on to clothing, but point it to the side until the steam
supply is stable . After that, you can start steaming .
ATTENTION! Be careful not to get burns. The steamer
can be used both vertically and horizontally.
• During operation, make sure that the water in the tank is
enough, top up if necessary .
ATTENTION! Filling water during operation is strictly
done only when the steam supply button is off.
• When steam is finished, turn off the appliance using the
steam supply button (3) and from the outlet . When turned
off, the steam supply does not stop instantly . It takes a few
seconds for the remaining steam to leave the boiler .
• Remove the nozzle and drain all remaining water from the
tank (5)
• Allow the appliance to cool completely . After that you can
put it in a storage place .
MAINTENANCE AND CARE
Always disconnect the mains plug and allow the steam
cleaner to cool down before performing any maintenance
work .
TROUBLESHOOTING
Often, failures have simple causes and you can do the
troubleshooting yourself using the following overview . If
you are in doubt or if the failure is not listed here please
contact the authorized customer service .
Danger
Repair works may only be performed by the authorized
customer service . Always disconnect the mains plug and
allow the steam cleaner to cool down before performing
any maintenance work .
DECREASED STEAM AMOUNT
Appliance is decalcifi ed .
Decalcify appliance .
ENVIRONMENTAL PROTECTION
The packaging material can be recycled . Please do not
place the packaging into the ordinary refuse for disposal,
but arrange for the proper recycling .
Made in China .