BONFIGLIOLI Vectron AEC 401 Series, Operating Instructions Manual

Page: 77 / 90

11/17 Operating Instructions AEC 77
Key Meaning
CANopen
F23
nn Heartbeat error, nn = triggering node.
CM module identification
F24 00
Unknown CM module. Verify compatibility of firmware and CM module
EM module identification
F25 00
Unknown EM module. Verify compatibility of firmware and EM module
Industrial Ethernet
F27 nn
Industrial Ethernet error. Please note the instructions on the Ethernet module used.
User error VPLC
F30 3n
Internal PLC function error caused by the user. Please refer to VPLC user manual.
Optional components
F0A 10
Data transmission from control unit KP 500 to the frequency inverter not possible. At least one
file must be stored in the control unit.
F0B 13
The communication module was fitted to slot B without disconnection of the mains voltage,
switch mains voltage off.
Internal monitoring
F0C 40
This error is triggered after 6 warm starts in less than 3 minutes because there will probably be
an error in the programming in the PLC or the function table. In addition the function table will
be stopped (P.1399 = 0 in RAM only).
11.1.2 Output signals in the case of error messages
Errors are signaled via digital signals.
162 -
Error Signal
1) A monitoring function reports an error displayed via Parameter
Current Error
259.
3 - 2)
1) For linking to frequency inverter functions 2) For output via a digital output
In addition to fault messages mentioned, there are further fault messages. However these messages are
only used for internal purposes and are not listed here. If you receive fault messages which are not listed
here, please contact the BONFILGLIOLI customer service.
Please save the parameter file on your PC before.
11.2 Error environment
The parameters of the error environment help troubleshooting both in the settings of the frequency inverter
and also in the complete application. The error environment documents the operational behavior of the
frequency inverter at the time of the last four faults.
Error environment
No. Description Function
330 DC-Link Voltage Direct voltage in DC-link.
331 Output voltage
Calculated output voltage (motor voltage) of the frequency
inverter.
335 Phase Current Ia Measured current in motor phase U.
336 Phase Current Ib Measured current in motor phase V.
337 Phase Current Ic Measured current in motor phase W.