BONFIGLIOLI Vectron AEC 401 Series, Operating Instructions Manual

Page: 76 / 90

76 Operating Instructions AEC 11/17
Key Meaning
01 Interior temperature too low, check control cabinet heating.
Output current
F05
00 Overloaded, check load situation and ramps.
01 Instantaneous output current value too high. Check load.
02 Dyn. Phase-Current Limitation Check load.
04 Overloaded, check load situation and current value limit controller.
DC-Link Voltage
F07
00 DC link voltage too high, check deceleration ramps and connected brake resistor.
01 DC link voltage too low, check mains voltage.
02 Mains failure, check mains voltage and circuit.
03 Phase failure, check mains fuse and circuit.
05 Brake chopper
Trigger threshold
506 too small, check mains voltage.
Electronic voltage
F08
01 Electronics voltage DC 24 V too low, check control terminal.
04 Electronic voltage too high, check wiring of control terminals.
Output frequency
F11
00 Output frequency too high, check control signals and settings.
01 Max. frequency achieved by control, check deceleration ramps and connected brake resistor.
10 Overfrequency. See application manual "Hoisting Gear Drives".
Modbus and VABus
F20 10 Communication error according to parameter
CM: VABus Watchdog Timer
413.
CANopen
F20
21 CAN Bus OFF
22 CAN Guarding
23 Error state
24 SYNC error (SYNC timing)
25 CAN error state
26 RxPDO1 length error
Number of received bytes differs from mapping. 27 RxPDO2 length error
28 RxPDO3 length error
2A CAN RxPDO1 Timeout
2B CAN RxPDO2 Timeout
2C CAN RxPDO3 Timeout
System Bus
F21 nn
Malfunction message in system bus master with malfunction in system bus slave
nn = node ID of slave (hex)
F22
00 Communication fault, system bus, timeout Sync telegram
01 Communication fault, system bus, timeout RxPDO1
02 Communication fault, system bus, timeout RxPDO2
03 Communication fault, system bus, timeout RxPDO3
10 Communication fault, system bus, bus Off