A.
Slide two Pillow Block Bearings (45) onto lower shaft on Main Leg Press Pivot (BD) and leave
allen screws loose.
NOTE:
Allen screws should both be on the inside.
B.
Attach two Pillow Block Bearings (45) to the plate at the front of Leg Press Frame (BB)
using:
Four 66 (1/2”x 1 3/4” hex head bolt)
Eight 93 (1/2” Washer)
Four 90 (1/2” nylon lock nut)
C.
Attach Front Leg Press Pivot (BE) and Shaft (BF) to Leg Press Frame (BB)
as shown using:
Two 41 (leg press oilite bushing)
Two 90 (1/2” nylon lock nut)
D.
Attach Foot Plate T-frame (BG) and Shaft (BF) to Front Leg Press Pivot (BE)
as shown using:
Two 41 (leg press oilite bushing)
Two 90 (1/2” nylon lock nut)
E.
Attach Foot Plate T-frame (BG) and Shaft (BF) to Main Leg Press Pivot (BD)
as shown using:
Two 41 (leg press oilite bushing)
Two 90 (1/2” nylon lock nut)
F.
Attach Foot Plate (BR) to Foot Plate T-frame (BG) using:
Two 64 (1/2”x 3 1/4” hex head bolt)
Four 93 (1/2” washer)
Two 90 (1/2” nylon lock nut)
Attach three End Caps (14) to each side of Foot Plate (BR) and front of
Foot Plate T-frame (BG).
Note:
You should now wrench tighten all bolts and nuts in this step.
Do NOT re-tighten any of the pad bolts or pulley bolts.
13
Be careful to assemble all components
in the sequence they are presented.
S T E P
mm
Inch
Most of the main frame parts in this step will have BLUE dots.
34
Summary of Contents for G9U
