BMW R 1100 S, Repair Manual

Page: 207 / 311

33.6
Removing input bevel pinion
•
Press out splined section of shaft.
•
If necessary, remove/install circlip.
•
Bolt the rear wheel drive to the retaining fixture,
BMW No. 33 1 510/511 .
•
Bolt the locking arm (1) to the retaining fixture.
•
Tighten grub screws until they are seated.
e
Caution:
The grub screws must not project, or the neck of the
housing could be damaged.
•
Screw threaded bushings (2) down on to the rear
wheel drive and secure them with the wheel
studs.
•
Heat hex nut (3) at the input bevel pinion to
100 °C (212 °F) and unscrew with w/f 36 socket
wrench insert and reduction adapter,
BMW No. 33 1 720 .
L
Note:
If necessary, use cross-handle with two tubular ex-
tensions.
•
Heat the housing to max. 120 °C (248 °F) and un-
screw threaded ring (4) with pin wrench,
BMW No. 33 1 700 .
•
To remove the input bevel pinion (5), remove the
crown wheel.
a
............................ See “Removing crown wheel”
S330020
h 100
h 120
S330030
33 1 700
33 1 720
33 1 510
2
1
5
h 120
w
w
4
3