TROUBLESHOOTING SUGGESTIONS
SUGGESTED REMEDY
Check / reset circuit breaker
Turn switches on.
Set for desired temperature
Allow to cool, reset hi-limit reset
Examine wiring & connectors,
controller, power board and
heating element
Repair/replace as needed
Adjust controller
Use one (1) genuine Bloomfield
filter per brew
Thoroughly clean brew
chamber
Use correct grind and amount
of coffee
Check/reinstall gasket on
INSIDE of brew head
Clean spray disk
Check switch, timer, solenoid
Repair, replace as needed
Turn water supply ON
Clean strainer
Replace filter element
Disassemble faucet, clean
Replace solenoid
Delime faucet water tank
POSSIBLE CAUSE
Circuit breaker tripped, main
power switch or tank heat
switch turned off
Temperature setpoint too low
Hi-Limit safety switch tripped
Damaged internal component
or wiring
Timer out of adjustment
Too many filter papers or wrong
filter paper
Brew chamber dispense hole
plugged
Too much coffee or too fine a
grind
Spray gasket improperly
installed
Spray disk plugged
Damaged internal component
or wiring
Water supply OFF
Solenoid inlet strainer plugged
Water filter (if used) plugged
Faucet plugged
Damaged solenoid
Faucet water level probe limed-
up or has calcium deposits.
"service tank" indicator lit
SYMPTOM
Water won’t heat
Coffee level too high or low
Brew chamber overflows
Sprays water from brew head
No brew
No brew plus no flow from hot
water faucet
No flow from hot water faucet
Continuous flow or drip from
brew head
Poor coffee quality
Keep brewer and decanters clean.
Install a taste and odor filter in water supply, and replace
cartridges regularly.
Use a quality coffee with a consistent roast. Use proper grind
and amount of coffee per brew.
10
