SERVICING INSTRUCTIONS (continued)
IMPORTANT:
Water pressure
must be between 20 p.s.i and
90 p.s.i. flowing pressure.
If water pressure exceeds this
value, or if water pressure
varies greatly, a pressure
regulator must be installed in
the water supply line.
IMPORTANT:
Before setting
assembly into tank, make sure
tank lid gasket is properly
seated on flange of lid.
IMPORTANT:
When replacing
thermostat, be sure a new seal
washer is in place around the
thermobulb capillary tube.
Tighten gland lock nut only
enough to ensure no water
leakage. Excessive tightening
is not necessary.
IMPORTANT:
When replacing
heating element, also replace
seal gaskets.
BREW TIME ADJUSTMENT
The amount of water dispensed automatically during a brew cycle
is controlled by the BREW TIMER.
Place empty decanter under the brew chamber. Press BREW
button. Brewer should dispense one full decanter of water. To
adjust amount:
Remove brew chamber and button plug. Adjust TIMER knob;
clockwise increases time. Run several cycles to check amount of
water delivered. Replace button plug.
REMOVE TANK LID ASSEMBLY
Disconnect brewer from electric power. Turn
OFF
water supply.
Remove top panel.
Disconnect fill and outlet tubes from tank lid fittings.
Disconnect all wiring from hi-limit, thermostat and heating
element.
Loosen two lid retainer nuts. Slide retainer out of the way.
Remove cover assembly by lifting it straight up.
Reassemble in reverse order.
REPLACE THERMOSTAT
Unplug brewer. Remove top panel.
Disconnect wiring from thermostat. Loosen screws holding
thermostat to bracket.
Loosen thermobulb gland nut. Withdraw thermobulb from lid.
Reassemble in reverse order. Adjust thermostat per page 12.
REPLACE TANK HEATING ELEMENT
Remove tank lid assembly per above.
Remove two hex nuts holding element to cover. Pull element
from mounting holes.
Reassemble in reverse order.
REPLACE SOLENOID
Disconnect brewer from electric power. Turn
OFF
and
disconnect water supply from brewer inlet fitting.
Remove front panel. Remove two screws holding access door in
place. Remove access door and solenoid. Unscrew inlet fitting
cap to release solenoid from door.
Remove wiring from solenoid.
Remove tubing from old solenoid and transfer to new solenoid.
Reassemble in reverse order.
13
