8
EQAM-420B
User Manual
Description:
Following are pictures of the front and rear of the unit:
GIGE# 2 & 1 DATA:
RJ45 connectors for 1000Base-T Ethernet (GigE) interface for streaming IP inputs.
-20
d
B QAM RF TEST:
"F" female connector for RF QAM output signal, 20dB lower than the actual RF QAM output. Used for test purposes,
without disconnecting the unit.
OUTPUT STATUS MODULE LEDS # 1, 2, 3, & 4:
LED is Off = corresponding RF module board is not installed.
LED is Red = issue with the corresponding RF module board.
LED is Orange = not all assigned channels have IP streams enabled and streaming.
LED is Green = corresponding RF module board functioning correctly and all assigned channels have IP streams
enabled and streaming.
LOCAL CONTROL #1 & 2 (10/100):
Two (2) RJ-45 connectors for 10/100-BaseT Ethernet interface. The Local Control # 1 can be used as an EAS trigger
input. The Local Control # 2 port is reserved for future use.
REMOTE CONTROL (10/100):
RJ45 connector for 10/100Base-T Ethernet interface for monitoring and configuring the unit via any standard web
browser. It can also be used as an EAS input trigger. Only static IP address can be assigned to this interface. The
factory default value is 172.16.70.1.
POWER:
LED is Green = AC power is detected.
LED is Off = indicates (i) AC power is not connected, or rear panel power switch is Off or (ii) AC power is connected
but the power supply is defective. The unit must be sent to Blonder Tongue for repair for condition (ii).
STATUS LED:
Displays the status of the Operating System (OS) of EQAM-420B.
Flashing Green = OS valid and operational
Solid Green or Off = OS not valid or not operational
IP RESET:
When pushed and held for about 10 seconds, resets the IP address, Usernames, and Passwords to Factory default
values as follows:
IP address = 172.16.70.1
Username = Admin (case-sensitive)
Password = pass (case-sensitive)
1
1
2
3
The Local Control is only used if the user has selected EAS trigger through local control on the EAS tab.
4
5
6
7
8
2
3
4
5
6
7
8
