Blodgett MT2136 Series, Service And Repair Manual

Page: 5 / 94

MT2136
1-1
OVEN SPECIFICATIONS
VENTILATION REQUIREMENTS
The hood should completely cover the unit with an
overhang of at least 6" (15 cm) on all sides not adjaĆ
cent to a wall. The distance from the floor to the
lower edge of the hood should not exceed 7' (2.1
m). The ventilation system should replace 80% of
the exhaust volume with fresh make up air.
TABLE 1 should be used as a guideline.
Single Double Triple
CFM 500Ć600 1000Ć1200 1500Ć1800
M
3
/min 14 Ć 17 28Ć34 42Ć51
TABLE 1
ELECTRICAL SPECIFICATIONS
NOTE: Three Phase hookup is not permitted on
gas models.
WARNING: DO NOT INSTALL A HIGH LEG" TO
ANY CONVEYOR OVEN!
Installations within the U.S.
MT2136G ovens require a 15 amp, 60HZ, 1 F ,
120/208Ć240 VAC, 4 wire service consisting of L1,
L2 neutral and ground. See FIGURE 1. Use 90 C
wire and size to National Electric or local codes.
MT2136E ovens are available in either 1
F or 3 F opĆ
tions. Single phase models require a 15 amp, 60
HZ, 208Ć240 VAC 3 wire service consisting of L1, L2
and ground. Three phase units require a 15 amp,
60 HZ, 208Ć240 VAC 4 wire service consisting of L1,
L2, L3, and ground. See FIGURE 1. Use 90 C wire
and size to National Electric or local codes.
MT2136G - U.S. Installations
MT2136E - Single Phase U.S. Installations MT2136E - Three Phase U.S. Installations
L1
L2
Oven Supply
L3
208Ć240
L1
L2
208Ć240
Oven Supply
L1
N
120
Oven Supply
L2
120
208Ć240
FIGURE 1