OPERATING MODES
73
Instructions within the command mode
Selection of the control level
•
<M> or <m>
The following commands are executed by the ‘Master’ (default after call of the
command mode)
•
<S> or <s>
The following commands are executed by the actively connected ‘Slave’
Direct selection of ports
•
<SHIFT> + <x>
Switch the selected device (through <M> or <S>) on port x (with x = number of
the port) – Caution! Applies only to the selected level!
•
<x>, <RETURN>
or
•
<0>, <x>, <RETURN>
Switch the Remote Unit (console) to the Local Unit 0x (the port 0x) (with x =
number of the port) – Caution! Applies only to the selected level!
•
<M>, <x>, <S>, <y>, <RETURN>
or
•
<M>, <0>, <x>, <S>, <0>, <y>, <RETURN>
(Only in cascaded applications!)
Switch the master to port 0x and the attached
slave on port 0y (with x and y = number of the ports) - Caution! Afterwards the
slave is the selected level!
Sequential selection of ports (depending on the selected control
level)
•
<
Î
>
(arrow key right)
Switch the console to the next port. After reaching the last port, the first port
will be selected.
•
<
Í
>
(arrow key left)
Switch the console to the previous port. After reaching the first port, the last
port will be selected.
•
<
Ï
>
(arrow key up)
Switch the console (bypassing unoccupied ports) to the next port. After
reaching the last port, the first port will be selected.
Summary of Contents for ACX4000
