About the device
Operating instructions iS10 / iS20
12
38019417000 en
2
A yellow mark of conformity is affixed to the load receptor of the scale,
with the inscription "Gesichert von BIZERBA" (for scales with a yellow
mark of conformity, the valuation of conformity has been carried out by
Bizerba). Verifications must be carried out by the operator of the scale
according to the legal requirements.
Verification-related notes for non-EC countries
The statutory regulations of the specific countries must be observed.
2.9
Metrologically approved data storage
The verifiable data memory serves to save verifiable measuring data. The recorded weigh-
ing results are saved (non-volatile) with a consecutive number.
2.10
Regulations of approval for weighing data memory
The points listed below are prescribed by the EC type test certificate; these must be abso-
lutely observed by the user. The following conditions must be fulfilled in relation to the
long-term storage of weighing results:
–
Weighing results must be stored together with an identification, so that each weighing
process of each weighing result can be easily assigned and verified if this should be
necessary. These identifications must also be specified for documents that have been
created with additional devices.
–
If taring was performed, tare and gross values have to be stored.
–
Contracting parties must be able to verify the stored weighing results.
Business documents that are created by an additional device not subject to statutory met-
rological inspection in accordance with the preliminary comment to Appendix 1 of directive
2009/23/EC, must contain the following information:
–
Identification for each weighing conveyor.
–
When used in Germany, an additional note is required stating that, based on the iden-
tification information, the weighing results can be compared to the stored weighing re-
sults in compliance with the guidelines.
2.11
Operating conditions
Please contact us or our customer service departments if you have any doubts concerning
the practical application of these conditions.
Protection type, temperature and air humidity
The permitted values and the protection type can be found on the device identification
plate and in the Technical data.
Air convection
In order to prevent unacceptable heating, there must be free air convection around the de-
vice.
