① Before lowering the lift to the lowest, move Jacking Beam to Storage Spot.
※ Storage Spot is the spot of Jacking Beam Pit Cover, and located at front
and rear of the lift. There are Jacking Beam Stoppers at Front and Rear
side end of Drive-On Plate. Make sure to move Jacking Beam until Jacking
Beam hit the Stopper.
① Make sure Supporter of Upper Lift is lowered to lowest
② For Alignment Model (MUS40HU & HUL), Make sure to insert Fixing Pin for the
Turning Radius Gauge and Slip Plate.
③ Drive out vehicle slowly
If trying to lower the lift to lowest before moving Jacking Beam to Storage Spot, it
could damage the lift and Jacking Beam.
DO NOT start or stop vehicle aggressively on the Drive-On Plate. Or it could result in
damage to the lift and serious accident.
