③ After Drive-On Plate stopped lowering, keep
pushing
"Lock"
button and
"Down"
button of
Lower Lift together for about 2 seconds. Then
both sides Lowering Stop Hook engage with
Lowering Stop Rack without fail.
④ After servicing vehicle, push
"Up"
button of Lower
lift for approx. 50mm.
⑤ Push
"Level"
button and rectify the height of Drive-On Plate.
Make sure to check and confirm that all Hooks would be
engaged with same height racks before pushing "Lock" button.
If pushing "Lock" button when Hook end is halfway like left
side drawing (Hook end is at the Rack end), Hook end could be
engaged with other height rack end, and could damage lift.
Unbalance of Drive-On Plate between Right and Left side can occur when
raising Drive-On Plate after servicing vehicle. But this unbalane is not
abnormal. When alignment servicing work is finished, make sure to
rectify the unbalance by pushing "Level" button. Refer to Page 25
『
9-
4-2 Rectifying the Unabalance in Alignment Servicing
』
, and follow the
instruction.
