"Lock"
button
Push
"Down"
button of Upper Lift
『 How To Lower Upper Lift (Supporter) 』
■ Swing Board and Slide Arm was not used when lifting vehicle
■ Swing Board and Slide Arm was used for lifting vehicle
① Push "Down" button of Upper Lift to lower the Upper Lift.
② Once Supporter leave (come off) lifting point, stop lowering (release button).
③ Remove Attachment and store Swing Board and Slide Arm back.
④ Push "Down" button of Upper Lift again and lower the Upper Lift to lowest.
(Keep pushing button until Upper Lift is lowered to lowest)
If keep pushing
"Lock"
button, Drive-On Plate lowers without releasing Lowering
Stop Hook. This locking operation is for the alignment servicing.
If need to use this function, refer to Page 25『 9-4-2 Rectifying the Unabalance
in Alignment Servicing 』, and follow the instruction.
① Push "Down" button of Upper Lift to lower the Upper Lift.
Keep pushing button until lift was lowered to lowest.
Swing Board
Attachment D
Slide Arm
･
If Lowering Stop Hook device can not be released in lowering operation, lift up slightly
and then lower thre lift.
･
Make sure to lower the Supporter to lowest. Or it may damage the vehicle and lift, and
cause malfunction of the lift.
･
DO NOT push "Up" button just after pushing "Down" button. If "Up" button is pushed
just after pushing "Down" button, Lowering Valve could be kept open, and lift may
keep lowering. Make sure to wait 1 to 2 seconds before pushing "Up" button. This
symptom is normal.
