1. DO NOT modify the lift without permission from the manufacturer. Failure to comply
may result in insufficient performance of the lift and lead to serious accident.
2. When an abnormality is detected during use or inspection, stop the use of the lift
immediately and repair. DO NOT use lift until the repair is completed.
3. This lift is not weatherproof and is not to be used outdoors or for vehicle washing.
4. Do not supply air with air pressure exceeding 1.0 MPa to the air filter regulator.
Or it may damage the air filter regulator.
5. The air filter regulator must be set to 0.7 Mpa. If it is set to over 0.7 Mpa.
Or it may damage the Selex Valve.
1. Perform measuring alignment within load capacity and applicable vehicle.
Refer to Page 25 『 Levelling Accuracy When Measuring Alignment 』
2. When Driving-In and Driving-Out the vehicle, make sure to insert fixing pin into
Turning Radius Gauge and Slip Plate.
If Driving-In and Driving-Out without fixing pin inserted, it may damage Turning
Radius Gauge and Slip Plate.
Refer to Page 27 『 Cautions on Alignment Servicing 』
3. Drive in the vehicle straight on the Drive-On Plate towards the center of Drive-On
Plate without deviation of the vehicle. And park the vehicle so that front tyres
position on the center of Turning Radius Gauge.
4. Do Not aggressively start, braking, turning on the Drive-On Plate.
Or it could lead to damage of the lift and vehicle.
5. When vehicle tyres are in free (neutral) position, make sure to set side brake,
and put 2ea.tyre stopper in front and rear of rear tyres.
Or it may result in the fall of the vehicle.
6. When lowering the lift to lowest, make sure the pointer of Turning Radius Gauge
is not outside of the lift before lowering the lift.
Or gauge may hit the pit and damage the Turning Radius Gauge.
7. The lift height of both sides may become unbalanced when lifting after servicing
vehicle. (This is not abnormal symptom). In such case, follow the instructions
of Operation Manual, and rectify the unbalance between right and left side Drive-On
Plate.
→ Refer to Page 25 『 Rectifying the Levelling in Alignment Servicing 』
