Lower the lift (including Upper Lift) to the lowest (floor LeveL) by pushing
"Down" button of Lower lift so that Drive-On Plate and Floor Level becomes same.
Refer to Page 21, 『 Lifting Operation of Upper Lift 』.
① For Alignment Model (MUS40HU & HUL), Make sure to insert Fixing Pin for the
Turning Radius Gauge and Slip Plate.
② Drive in vehicle parallel to the Drive-On Plate of the lift and evenly in its
width direction, and stop (park) the vehicle on the spot where Front Wheels
and Rear Wheels are located well balanced. Also pay attention in stopping
(parking)vehicle so that vehicle tyres are not hitting Supporter.
※ Applicable Vehicles - Passenger car, SUV, Light Truck (except Long body truck)
・
DO NOT lift up vehicle which is heavier than lift capacity.
・
DO NOT lift up vehicle with passengers or baggage inside.
・
Drive in and out vehicle slowly, and DO NOT start and stop vehicle suddenly.
・
Drive carefully when tyres or Drive-On Plate are wet to avoid slipping.
・
Make sure Drive-On Plate and Upper Lift are lowered to lowest before driving in
or driving out vehicle
