birddog NDI P200, User Manual

Page: 27 / 66

23
System Menu
PELCO ID: When using RS485 (PELCO P/D) control, set Camera ID to the controlled address. This value
is from 001-255.
IR-RECEIVE (Infrared Signal Reception): When this is set to OFF, the camera does not receive the sig-
nal from the infrared remote controller. Be sure to keep it set to ON when you use the infrared remote
controller. Note that you cannot set IR-RECEIVE to OFF when you operate the menu using the infrared
remote controller. To set it to OFF, use the appropriate VISCA controller.
DISPLAY INFO: When this item is set to ON, the camera configuration is displayed for approx. 3 sec-
onds on the screen when the camera is powered on or rebooted.
PRESET MEMORY: This feature allows you to save the image parameters to PRESET memory. Parame-
ters such as picture, white balance, exposure, focus mode, zoom positions can be saved with the pre-
set.
FACTORY RESET: Select this item to set camera back to the factory default setting. Press the HOME
button to confirm the action. All user settings for the camera will be deleted.
RELOAD PRESET 1: When set to ON, preset 1 is set to the Home position. The camera goes to the
Home position when it is powered on or reset.
AUTO FOCUS: Set the speed of auto-focusing from Low to Normal.
VIDEO FORMAT: You can change the camera video format. Select VIDEO FORMAT, press the “ ← ”
button to choose the video format, then press “ → ” (Pressing “ → ” button changes value on some prod-
uct models) or HOME button to confirm. After confirmation, press the HOME button again to restore
it. The camera will reboot by itself and the new video format is activated.
•
You can cancel it by pressing the MENU button.
•
Depending on the video client software you are using, some video software may need to be
restarted to obtain the new video format. You can select from the following video formats:
• 1080P:60/59.94/50/30/29.97/25, 1080I:60/59.94/50, 720P:60/59.94/50/30/25
NOTE: The camera video format can also be changed by setting the rotary DIP switch at the
back of the unit.
SV: Software Version Number that is currently running on the camera, you may need this information
for technical support.
SYSTEM MENU
PELCO ID
IR-RECEIVE
DISPLAY INFO
PRESET MEMORY
FACTORY RESET
RELOAD PRESET 1
AUTO FOCUS
FORMAT
SV 001
ON
ON
ON
ON
NORMAL
1080p29.97
V0B1100S36[...]
OSD
EXPOSURE
WHITE BALANCE
PICTURE 1
PICTURE 2
PAN TILT ZOOM
SYSTEM