LED window release the buttons.
TOUCH CONTROL INDICATOR LIGHTS
LED WINDOW
:
Shows the level of maintenance sanitizing. A service code will
be displayed in case of a problem. The letter
U
will appear to
indicate Usage Sense (activation of BiO2 when the jet pump is
on) if so equipped.
READY
: When light is on: BiO2 has power.
CELL ON
: When light is on: BiO2 is producing sanitizers.
CHECK SALT
:
Flashing light: Salt level is high, test salt level and
adjust.
Steady light: Salt level is too low: add sodium bromide and
non-iodized table salt (sodium chloride). Please refer to page
(11) of this manual.
SERVICE
: When light is on: check the LED window for a service
code. Contact dealer or BiO2 Help Desk 1-800-516-4028. Please
refer to page (8) of this manual.
OPERATING BiO2
With this basic understanding of the BiO2 Components and their
function, let
=
s discuss how to operate the unit.
STEP 1. GETTING STARTED
1.
Drain your spa and start with fresh water
. Follow your
dealer's recommendations for start up. Adjust the pH to
between 7.2 and 7.8.
2.
Add sodium bromide and non-iodized table salt (sodium
chloride) to your spa water as follows
. Add 58 grams of
sodium bromide (scheduled or registered, for use in spas,
under the Pest Control Products Act) and 454 grams of
non-iodized table salt (sodium chloride) for every 378.5
litres (83.3 imp gal) of water in your spa. This special
combination of sodium bromide and sodium chloride will
dissolve rapidly. Turning on the spa's jets will help
dissolve the sodium bromide and sodium chloride.
