12
6. How to install in different places
In case of power failures.
Turn off the water branch pipe in case of power failures.
(When letting water flow through, purified water will come out)
Use the product normally when the power is recovered.
In case of suspension of water supply.
Do not use the product.
Stop the water from flowing through when the water supply is suspended in the middle of using the product.
7. In case of power failures or suspension of water supply
When the water supplied is resumed, let the water flow sufficiently for direct water supply or showering in order to
help the inside air and other materials come out. Without going through such steps, the water still can be used
normally, but with the risk of drastic decrease of the life span of the filter when allowing air or other materials flow
through the main body.
A) When installing the product onto the wall
Apply water to the installation drawing and place it onto the wall while
keeping the horizontality
Of those nailing positions at the width (1~3) or the height
(2 ~4), choose the convenient ones for driving 2 nails
Place the hanging holes of the product onto the nails
: Positions of nails
B) When placing the product on the sink deck and its supports.
- Place the main case of the product on an appropriate position.
When the above steps are finished, use the hose to connect the valve cock
of the adapter to the inlet pipe at the bottom of the main case of the water
ionizer.
First of all, assembling the flexible pipe to the half-moon shaped alkaline water outlet at the
upper part by turning it clockwise.
1. Measure the distance between the place for installation and the adapter installed to the water tap and then
cut the hose with an extra length.
2. Cut the PVC hose for the acidic water into the length of 50~70cm and place it lower than the product.
The product can be used conveniently by placing it on any place by applying the wall mounting or stand type
(Turn table) depending on the place of installation.
After installation, connect the product to the AC120V power line.
When the water flows through the product, the power will be turned on automatically. Then, select Purified
Water menu to enable the water branch pipe to open and close repeatedly to allow the water to flow for 2~3
minutes freely. Then push the pH button to set the desired concentration and compare it with pH comparison
sheet. The black water that will come out is the filter dusts flowing with water, not dangerous to the body.
(Refer to How to measure the pH value in Page 18)
5. Steps for assembling the component before installing them
Should use the standard inlet hose (1/4") and fix the valve cover in the direction of the hose to prevent the
hose from being bent or the fastening nut from being loosened. The safety pin needs to be inserted before
using the water.
Caution
Do not install the product in the following areas:
- If not followed, malfunctioning can be caused.
You are required to contact the sales shop or the specialized installer for queries when you attach
the product to the wall.
Improper mounting may result in the product falling of, accident or mal-function.
If vibration and impact can be felt
If direct sunlight comes in
If there are lots of moisture or dusts
lf heat of fire can be felt
If horizontality can not be acquired
If bathroom is installed or winds and rains can affect
If there is a risk of breaking due to freezing
lf damage can be caused to the product
