ASSURANCE
GDS®
PPMX
USER
MANUAL
11
DC
Power
Output
–
The
top
terminal
block
has
one
+12V
DC
output,
which
is
labeled.
The
PPMX
has
one
functional
USB
host
port
(the
middle
port)
on
the
rear
panel.
The
top
port
on
the
rear
panel
is
not
supported.
The
USB
ports
can
be
used
to
connect
USB
drives
(which
can
also
be
seen
by
the
tablet
when
plugged
into
the
PPMX),
keyboard,
mouse,
or
any
other
compatible
device
(heater/chiller,
barcode
scanner,
or
shaker,
for
example).
The
USB
device
port
is
used
for
communication
between
the
PPMX
and
the
tablet
or
computer.
A
USB
cable
is
provided
as
a
standard
accessory.
Refer
to
the
diagram
for
the
location
of
the
USB
device
port.
The
Ethernet
Port,
RS
‐
232
and
HDMI
are
not
supported.
1
Input/Output
(Green)
2
USB
host
(Not
Supported)
3
USB
host
4
Ethernet
(Not
Supported)
5
USB
device
6
RS
‐
232
(Not
Supported)
7
HDMI
(Not
Supported)
8
Power
receptacle
9
Power
switch
(MAINS)
Use
the
power
cord
on
the
external
power
supply
to
make
the
connection
between
the
power
receptacle
on
the
PPMX
and
the
external
power
supply.
The
connection
from
the
external
power
supply
to
the
PPMX
uses
a
connector
with
a
locking
collar.
Check
the
alignment
of
the
pins
and
then
push
it
in
until
it
clicks
and
locks
in
place.
To
disconnect,
pull
back
on
the
locking
collar
and
then
disconnect
the
cable
from
the
rear
panel
of
the
PPMX.
Locate
the
appropriate
power
cord
for
your
line
voltage
and
then
make
the
connection
between
the
external
power
supply
and
the
AC
power
source.
Install
the
Power/USB
Cabling
kit
by
following
the
supplied
instructions.
