4
Installation and Startup
7.
Place the Camera board in the slot
The connector on the Camera board must face the back of the computer. Insert the board, pressing
firmly so that it slips into place.
8.
Re-mount the screw removed in Step 6.
This screw will hold the board in place.
9.
Re-mount the computer cover and its screws.
Proceed to section 1.2.2, Setting up the System.
1.2.2 Setting Up the System
To set up the computer, you will need to make the connections shown below. Be sure to remove the small
metal antistatic plug from the Imager’s computer cable connector. This plug protects the connector during
shipping. Remove and save it for storage or shipment.
Each cable is designed to fit a specific connector; where there is some doubt, note the number and configu-
ration of the pins in the connector. Refer to Figure 3 and to the computer vendor’s documentation that was
shipped with the computer. If you are using any peripheral computer devices with your system, refer to that
device’s separate documentation for connecting to the computer.
Figure 3. Glyco Doc Imaging System Cable Connections
MONITOR
COMPUTER
IMAGER
PRINTER
MOUSE
KEYBOARD
Summary of Contents for 170-6555
Page 47: ......
