3
Installation and Startup
To install the camera board, follow the procedure below.
1.
Turn off your computer and unplug the power cord.
This procedure assumes the computer was previously set up and used for other applications.
2.
Turn off all connected peripheral devices.
Connected devices include printers, monitors, etc.
3.
Remove the cover from your computer.
Refer to the documentation supplied with your computer system.
4.
Discharge static electricity.
Make sure the computer is turned off and unplugged! Discharge static electricity by touching, with the
back of your hand, a grounded metal surface such as the metal frame of the computer.
5.
Locate any unused 16-bit bus expansion slot inside your computer
Expansion slots almost always run from the front of the computer to the back. A 16-bit slot is divided
into two sections. (See Figure 2.)
6.
Remove the slot cover, which is located on the back of the computer.
Removing the small slot cover on the back of the computer will allow you to attach a cable to the
Camera board.
Figure 2. Installing the Camera Board in the Computer
Summary of Contents for 170-6555
Page 47: ......
