Billion BiGuard 30, User Manual

Page: 122 / 211

122
Configuring a New VPN Connection
Connection Name: A user-defined name for the connection.
Tunnel: Select
Enable to activate this tunnel. Select Disable to deactivate this
tunnel.
Interface: Select the interface the IPSec tunnel will apply to.
WAN1: Select interface WAN1
WAN2: Select interface WAN2
Auto: The device will automatically apply the tunnel to WAN1 or WAN2
depending on which WAN interface is active when the IPSec tunnel is being
established. Note. Auto only applies to Fail Over mode. For Load Balance mode,
please do not select "Auto". In Load Balance mode, Auto will be forced to WAN1
interface if Auto is selected.
Local: This section configures the local host.
ID: This is the identity type of the local router or host. Choose from the
following four options:
WAN IP Address: Automatically use the current WAN Address as ID.
IP Address: Use an IP address format.
FQDN DNS(Fully Qualified Domain Name): Consists of a hostname and
domain name. For example, WWW.VPN.COM is a FQDN. WWW is the host name,
VPN.COM is the domain name. When you enter the FQDN of the local host, the