I
NSTALLATION
A
IR
HEATER
en-42
en
Note:
n
The
b-touch
control panel is no longer necessary for
purposes of operation. After you have gone through
the installation guide, it can be removed. However,
do keep it, so as to be able to adjust settings at a
later stage.
2.12 Unit finishing
1. Close the electronics housing: replace the cover
2
and fas-
ten the screws
1
at the bottom of the housing.
2.13 Switching ON and checking operation
For all models:
1. Check the following connections:
- power supply;
- control cable(s) between control panel and unit(s);
-
If applicable:
external control components.
For all models:
1. Switch the mains supply on.
Caution:
c
Make sure that the unit’s power supply voltage
matches the local mains voltage.
The unit’s power supply voltage is displayed on the
type plate.
2. Set the isolation switch to 1. (if applicable: on all units)
