NOZ2 M
ANUAL
I
NSTALLATION
Manual version 6.0 - North America (10-03-2017)
en-33
en
7. Using the 2 small screws and rings, screw the switch to the
surface-mounted box or standard junction box.
8. Fit the shut-off cap.
9. Fasten the hexagonal nut.
10. Fit the adjustment button: Press this on firmly and set to
position ‘0’.
2.9.3 Connecting the controller to the unit
Warning:
w
The unit must be earthed.
1. Lead the control cable into the unit via the cable gland at
the top of the electronics housing.
2. Connect the cable to terminal block X60
1
, in accord-
ance with the wiring diagram supplied.
Connecting multiple units with a single controller
Note:
n
2.9.1 Special points regarding the
to see how many units can be connected
to the controller.
1. Lay the cable between the electronic housings of the units
to be connected
2. Feed the cable into the electronic housings of both units.
3. Connect the cable in both units to terminal block X60
6
,
in accordance with the wiring diagram.
4. Repeat steps 1 to 3 for each unit to be connected.
