I
NSTALLATION
A
IR
HEATER
en-36
en
2.10.2 Mounting and connecting the control panel
1. Lay the control cable.
2. Slide the control panel out of the wall holder.
3. Connect the control cable to terminal X397.
Caution:
c
Ensure that the wall behind the wall holder is even.
Caution:
c
Place the control panel in the housing supplied if
class IP54 is required. The openings for the cable
guide must be on the bottom.
4. Screw the wall holder onto the junction box or against the
wall.
Caution:
c
The control panel should only be put back into the
wall holder when the power supply of all the
connected units has been switched on.
2.10.3 Connecting the control panel to the unit
Warning:
w
Make sure that the mains supply group with
which you are working has been turned off.
1. Lead the control cable into the unit
2. Connect the cable to terminal block X530
1
, in accord-
ance with the wiring diagram.
Connecting multiple units with a single control panel
1. Lay a 2-core cable between the electronic housings of the
units to be connected
2. Feed the cable into the electronic housings of both units.
3. Connect the cable in both units to terminal block X60
2
,
in accordance with the wiring diagram.
4. Repeat all steps for each unit to be connected.
