VisiPC Software Manual Part 1 – Visilynx 3 Configurator
INS00231 Issue 4 Page 60 of 88
4.14 Sequence Settings
‘Sequence Settings’ allows you to configure sequences of cameras or views to be shown at
when required. Up to 64 sequences may be selected.
Each configured sequence provides from 2 to 63 steps. When a sequence step is selected,
the step number is highlighted, as shown below at Step 1.
Figure 57 Sequence Settings Screenshot
•
Use the
Sequence
selector (bottom right) to select the one to configure.
•
Type
: Choose between ‘Camera’ and ‘View’.
•
Number
: Select a number for the camera or view.
•
Node
: Choose the node to which the video source is connected. ‘Node’ is only used
when ‘Type’ is ‘Camera’.
•
Preset
: Designate a preset number from 1 to 99 for the camera position, if required.
‘Preset’ is only used when ‘Type’ is ‘Camera’.
•
Speed
: Set the speed of movement between each sequence step from ‘1’ to ‘100’
percent; where 100% = full speed. ‘Speed’ is only used when ‘Type’ is ‘View’ or ‘Preset’
is used.
•
Dwell
: Set the dwell time for each step between 1 and 255 seconds.
•
Insert
: adds a new step before the highlighted step. The ‘Total’ box to the left of the
Insert
button always shows the current number of steps. Each new ‘Step’ is given
default values for each setting on the line, which should then be modified as appropriate.
•
Insert After
: adds a new step after the highlighted step.
