34
2
2
1
8
4
5
7
6
3
2
10
1
9
10
3
3
6
7
8
10
5
4
9
10
3
3
6
7
8
10
5
4
9
10
3
3
6
7
8
10
5
4
9
10
–
Continue to thread points
(4)
–(
10)
.
Before threading eye of needle, slip thread behind
thread guide
(9)
located on the bottom of the needle
holder for Coverstitch.
PLEASE NOTE:
Slip thread into the front slot on the thread guide
(5)
and lower slot of take-up lever cover
(6)
.
Then slip thread into the left slot on the thread
guide
(7)
, and into the left slot on the thread
guide
(8)
.
–
Thread the pre-tension guide by pulling the
thread towards the left until it slips under guide
(2)
. Then pull thread along the right side of pre-
tension as illustrated.
–
While holding thread with fingers, pass it
between the tension discs and pull thread down
to make certain it is properly located in between
the tension discs
(3)
.
–
The position of the thread must be behind the
thread guide.
–
Draw about 10 cm (4 inches) of thread through
needle eye towards the rear of machine.
–
Place the thread to the back, under the presser
foot.
–
Thread the eye of the left needle
(10)
.
PLEASE NOTE:
Use of tweezers in the looper cover will make
needle eye threading easy.
