Fig. 75
3.
Apply Loctite® 2440™ to post stud after set.
AUTODRIVE ASSEMBLY
ADJUSTMENTS (X13A, X13AE)
Disconnect the electrical power to
the machine and follow lockout /
tagout procedures.
Eccentric Pin Adjustment
NOTE:
Eccentric pin is in adjustment when pulling
clutch engage rod there is resistance during last 1/4
to 1/8 of stroke. The resistance is the clip assembly
gripping the primary belt.
1.
Place primary belt in auto clip assembly.
Fig. 76
2.
Remove screws and square rail.
Fig. 77
3.
Loosen nut and adjust eccentric pin accordingly
1/4 turn at a time.
Fig. 78
4.
Tighten nut.
5.
Recheck proper operation of clutch engage rod.
6.
Install square rail.
7.
Check slicer for proper operation.
WICK REPLACEMENT
Disconnect the electrical power to
the machine and follow lockout /
tagout procedures.
1.
Remove arm assembly as outlined under ARM
ASSEMBLY.
2.
Remove round rail from transport arm.
3.
Remove old wick from inside transport arm.
X13 SLICER - SERVICE PROCEDURES AND ADJUSTMENTS
F25332 Rev. A (0718)
Page 28 of 36
