PUSHER ARM ASSEMBLY
Pusher Arm Removal
Disconnect the electrical power to
the machine and follow lockout /
tagout procedures.
1.
Remove product table as outlined under
PRODUCT TABLE.
2.
Remove two guide rail screws.
NOTE:
Do not allow guide rail to rotate while removing
the screws.
Fig. 6
3.
Remove pusher arm assembly from guide rail.
4.
Turn pusher handle CCW while preventing
pusher from rotating.
Fig. 7
5.
Remove pusher from pusher handle and shaft.
6.
Reverse procedure to install.
NOTE:
Apply Loctite® primer and Loctite® 242™ to
threads of guide rail screws. Screws will backout if
Loctite® and primer is not used.
7.
Check slicer for proper operation.
ARM ASSEMBLY
Arm Assembly Removal
Disconnect the electrical power to
the machine and follow lockout /
tagout procedures.
NOTE:
X13E and X13AE models are not equipped
with interlocks. When working on an E series model,
proceed past any step that refers to interlocks.
1.
Remove product table as outlined under
PRODUCT TABLE.
2.
Slide arm assembly all the way to end of stroke
(X13E, X13AE).
3.
Place slicer on its side, so it is resting on motor
housing.
4.
Supporting the arm assembly, squeeze the slide
bar to the unlocked position and lower assembly.
Fig. 8
5.
Remove screws and clevis pin, move slide bar
guide out of way.
X13 SLICER - REMOVAL AND REPLACEMENT OF PARTS
Page 9 of 36
F25332 Rev. A (0718)
