A.
Correct voltage supplied to slicer.
B.
Red power LED lit.
C.
Carriage tray secured.
1)
(X13A only) Slide bar switch closed;
control board signaled that carriage is
in place.
D.
Auto engage lever pulled out into engaged
position.
1)
Hall effect switch signals board that
auto mode has been selected.
NOTE:
Default settings are slow speed and full
stroke. However slicer will remember last settings
unless power has been removed from the slicer.
2.
Select speed - LED will indicate selection.
3.
Select stroke length - LED will indicate selection.
4.
Press start button - start switch closed.
5.
15VDC is applied to control board.
6.
Knife motor energized.
A.
Knife motor continues to run until stop
button is pressed.
NOTE:
Slicers equipped with timer assembly will shut
off after 15 seconds of no slicing.
7.
Auto motor energized.
A.
Motor finds home position.
1)
Hall effect switch is positioned under
magnet and control board is signaled.
B.
Carriage begins to move at selected speed
and stroke.
8.
Press stop button - stop switch opens.
9.
15VDC is removed from control board.
10. Knife motor de-energized.
11. Auto motor de-energized after returning to home.
X13 SLICER - ELECTRICAL OPERATION
Page 35 of 36
F25332 Rev. A (0718)
