Fig. 18
6.
Remove screws, clamp, and clevis pin.
Fig. 19
7.
Remove plugs and screws beneath plugs.
Fig. 20
8.
Remove top plate assembly.
NOTE:
Top plate assembly edge is sealed with RTV.
9.
Reverse procedure to assemble.
10. Check slicer for proper operation.
CENTER PLATE
Center Plate Removal
Disconnect the electrical power to
the machine and follow lockout /
tagout procedures.
1.
Close gauge plate.
2.
Move product table to home position.
3.
Turn center plate knob CCW until it lines up with
post stud.
Fig. 21
4.
Lift cover out and up.
Center Plate Installation
1.
Place center plate on shoulder studs with knob
lined up to fit over post stud.
X13 SLICER - REMOVAL AND REPLACEMENT OF PARTS
F25332 Rev. A (0718)
Page 12 of 36
