2.
Open gauge plate.
3.
Tape knife.
Fig. 51
4.
Remove gauge plate bolts.
Fig. 52
5.
Remove gauge plate.
6.
Place slicer on its side, so it is resting on motor
housing.
7.
Remove pin to disconnect clevis from slide bar.
Fig. 53
8.
Remove screws and clamp.
Fig. 54
A.
Remove cable from zipties.
9.
Unplug wire harness from control board.
10. Remove knife motor as outlined under KNIFE
11. Remove mounting screws and washers holding
upper housing to slicer base.
X13 SLICER - REMOVAL AND REPLACEMENT OF PARTS
Page 21 of 36
F25332 Rev. A (0718)
