PROGRAMMING
You can program the system using a LCD Keypad, or
using the
KYO300-KYO100
downloading software
from the Bentel
Security Suite
Software package (ac-
cessory item).
+
You CANNOT program the Hardwired Zone
Sen-
sitivity
and
Scheduler
parameters — except for
the
Max. no. overtime requests
and
Overtime
Request
options — from the Keypad.
You can record and playback
Voice Messages
,
and program the
Key/Card Codes
ONLY from a
Keypad.
If you are programming the system from a Keypad, refer
to the instructions in the “PROGRAMMING FROM
KEYPAD” manual.
+
This section provides information on the system
parameters, and should be referred to also when
programming from a Keypad.
Read this section thoroughly to learn how to install and
use the
KYO100-KYO300
software application.
1.
Install the
KYO100
-
KYO300
software application
as described in the
Security Suite
manual.
2.
Run the
KYO100-KYO300
application.
3.
Select the Control panel
Type
(refer to the
Cus-
tomer data
paragraph) and the
Firmware Release
(refer to the
Options
paragraph in the
Security
Suite
manual).
4. NOTE:
When programming the KYO 100, select
File > INIT
then setup the Panel Type and
Firm-
ware Release
in the
Parameters
window.
5.
Program the parameters (refer to the relevant para-
graphs for instructions).
6.
Download the programmed parameters (refer to
the relevant paragraph:
On-site Programming via
Computer
or
Remote Programming via Com-
puter
).
+
The programmed parameters can be saved on
hard or floppy disk, and downloaded to the Control
panel via modem or on-site. The programmed pa-
rameters can be renamed and reused for different
Customers (refer to “
Save
” and “
Open Customer”
in the “Bentel Security Suite” Manual).
The system parameters are organized in Pages. The
Programming Pages
in this section are congruent with
the
KYO300
software structure.
Configuration (Enrolling Devices)
On startup the Control panel will automatically enrol all
the BPI Bus peripherals (refer to “Power supply connec-
tion” under “INSTALLATION”). Any changes after auto-
matic enrollment must be made by the Installer.
During the polling process, the Control panel will
match
the interrogation result with the stored configuration
and, in the event of mismatch, will generate the relevant
warning.
+
If the Control Panel is connected to a computer, it
will be possible to view the configuration by loading
the Configuration page.
The Configuration section is divided into pages — one
for each type of device (Keypads, Input Expanders,
Output Expanders, Readers, Power Supply Stations
and Accessories).
The following programming instructions refer to param-
eters common to all BPI devices. For instructions on
how to program the parameters of a specific device, re-
fer to the relevant paragraph.
KYO 300-KYO100
PROGRAMMING
31