BenQ SX930, Service Manual

Page: 36 / 175

36
A minor defect is a defect that is not likely to reduce materially the usability of
its intended purpose, or is a departure from established standards having little
bearing on the effective use of operation of the product.
Note: If BenQ defect undefined failure, and it judged that is reduce the merchandisebility, BenQ
CM Inform this defect. After that parties make communication and decide how to solve.
6.0 EXPRESSION OF DEFECTIVES
Number of defects
Percent of defects = ------------------------------------------ X 100%
Number of products inspected
7.0 INSPECTION STANDARD
Unless otherwise specified, the inspection standard will be defined by MIL-STD-105E,
NORMAL INSPECTION LEVEL
Ⅱ
, SINGLE SAMPLING PLAN.
7.1 Acceptance Quality Level
7.1.1 Critical Defect:
When a critical defect is found, this must be reported immediately upon
detection, the lot or batch shall be rejected and further shipments shall be
held up pending instructions from the responsible person in relevant
department.
7.1.2 under normal sampling
Critical Defective : 0% AQL
Major Defective : 0.65% AQL
Minor Defective : 2.5% AQL
8.0 GENERAL RULES
8.1 The inspection must be carried out by trained inspectors who have good knowledge about
the product.
8.2 The inspection must be based upon the documents concerning the completely assembled
and packed product.