BendPak HD-7500 Series, Installation And Operation Manual

Page: 25 / 84

HD-7500 Series Four-Post Lifts
25
P/N 5900174 — Rev. C — March 2021
Raising the Crosstubes
At this point in the installation you need to manually raise the Crosstubes, as this makes it easier to
complete the rest of the installation tasks. Both Crosstubes need to be raised the exact same amount,
to the exact same height.
To raise the Crosstubes :
1. Using a Forklift or Shop Crane,
carefully
raise each Crosstube.
You probably want to raise the Crosstubes at least two feet off the ground, to have enough room
to work under them when routing the Lifting Cables, Return Line, Air Lines, and Hydraulic Hose.
Important
: The Slack Safety Locks will automatically engage when you raise the Crosstubes. They
cannot be engaged as you continue with the installation, so
they must be disengaged
.
2. To disengage the Slack Safety Locks after raising a Crosstube: raise and hold one end of a
Crosstube so the Primary and Slack Safety Locks are disengaged, push and hold the Sheave or
the Steel Piece in towards the Ladder and the back of the Post (this moves the Slack Safety Lock
so it cannot engage), lower the end of the Crosstube, then release the Sheave or Slack Safety.
The Primary Safety Lock engages, but the Slack Safety Lock does
not
; this is what you want.
3. Disengage the other three Slack Safety Locks as done in Step 2.
4. Once both Crosstubes are raised,
all four Primary Safety Locks are engaged
, and all four
Slack Safety Locks have been disengaged , you can continue with the installation.