Allon
®
User Manual
DDT-063-000 Rev C Belmont Medical Technologies
Page
36
of
106
C
HAPTER
4: O
PERATING
I
NSTRUCTIONS
General
This chapter contains:
–
A description of the controls, indicators, and connections for the Allon
®
device.
–
Detailed operating instructions for the Allon
®
system.
Controls, Indicators and Connections
Included in this section is a short description of the following:
–
Main Power Switch
–
Power Loss Alarm Disable
–
QCC – Quick Coupling Connectors
–
Sensor Sockets
–
Control Panel
–
Indicators
–
Displays
Main Power Switch
The main power switch, located on the rear side of the unit, switches the
Allon
®
device ON and OFF.
Power Loss Alarm Disable
The silver push button to the right of the main power switch on the back of
the unit turns off the yellow LED on the front of the unit. This LED will flash
each time the machine is powered down, loses power or is unplugged, and it
will continue for approximately 10 minutes or until the disable button is
pressed.
QCC— Quick Coupling Connector
The Quick Coupling Connectors are located at the front of the Allon
®
device and are
connected to the ThermoWrap
®
by means of the connecting tubes for wrap.
1. To connect the Tubes:
1. Lock the connecting tubes by pressing the metal ends of the tubes into each metal
connector on the device. When locked, a clicking sound is produced.
2. Verify that the tubes have been locked by lightly tugging them towards you.
2. To disconnect the Connecting Tubes:
1. Press the metal flange and pull out the connecting tubes.
