BEGA Gateway 70 588, Installation And Start-Up Instructions Manual

Page: 19 / 52

19 Gateway 70 588
Chapter 3 | Configuration
A command directed to the network address (broadcast
address: fffd) failed (status code: MAC:CHANNEL_ACCESS_
FAILURE).
This error may occur, if the component is temporarily not
available. This is usually a temporary radio transmission interference in your
ZigBee network, wherein control commands cannot be sent to
the target device.
This kind of error is often caused by external parasitic induction
and will be automatically fixed by the intelligent radio standard
being used.
If this warning message is displayed repeatedly, contact the
support.
Your ZigBee network denied access to the unauthorized
device 192.168.0.111. Authentication of a device has failed during the login attempt.
This is usually a mobile device, which had access to your ZigBee
network.
The update of the network component with the IEEE address:
00:1F:EE:00:00:00:00:01 has failed. Further attempts will
follow. The download of the new firmware for the appropriate
ZigBee component has been interrupted due to transmission
interferences or a power breakdown, for example. A new attempt
will be done automatically.
An update could not be performed. Further attempts will
follow. A ZigBee component has prematurely cancelled the download
attempt of a new firmware. A new attempt will be done
automatically.
Error messages (red highlighted)
Contents Explanation
Failed to initialize the Gateway Service.
If the error has not been resolved automatically after some
time, restart the gateway. An error occurred while initializing the integrated ZigBee adapter
of the gateway. This is an internal error, which should not occur
in general. Restart the gateway. If the error occurs repeatedly,
contact the support.
No ZigBee adapter found.
If the error has not been resolved automatically after some
time, restart the gateway. An error occurred while initializing the integrated ZigBee adapter
of the gateway. This is an internal error, which should not occur
in general. Restart the gateway. If the error occurs repeatedly,
contact the support.
The ZigBee adapter could not be started.
If the error has not been resolved automatically after some
time, restart the gateway. An error occurred while initializing the integrated ZigBee adapter
of the gateway. This is an internal error, which should not occur
in general. Restart the gateway. If the error occurs repeatedly,
contact the support.
Failed to initialize the gateway. Further attempts will follow. An error occurred while initializing the integrated ZigBee adapter
of the gateway. This is an internal error, which should not occur
in general. Restart the gateway. If the error occurs repeatedly,
contact the support.
The gateway is temporarily not available. Further attempts will
follow. During operation, an error occurred in the integrated ZigBee
adapter of the gateway. . This is an internal error, which should
not occur in general. Restart the gateway. If the error occurs
repeatedly, contact the support.
The component (IEEE address: 00:1F:EE:00:00:00:00:01)
does not respond to configuration attempts. Further attempts
will follow. This could be a temporary radio transmission interference in the
ZigBee network, wherein a configuration command could not be
sent to a target device or acknowledged.
This error can be caused by external parasitic induction, an
inactive ZigBee router or a deactivated target device and is
usually automatically fixed as soon as the affected device is online
or the error source has been disabled.
If this error occurs repeatedly, check if the affected device and
temporarily stored ZigBee routers are installed and properly
connected to power. If the problem still exists, contact the
support.