Bearcat BC-2016/CRC, Instruction Manual

Page: 34 / 95

34
2016
7
Cams & String Pots
Press ❼ to enter and diagnose each Cam sensor reading. The left and
right Cam PPU has a voltage and hertz reading. Below voltage the reading
on the left is the status of the circuit with the appropriate level being
low, high, or OK. The right side analyzes the feed back circuit with OK, or
corrupt describing a bad signal or no signal. The flashing red indicates a
problem. The Cam Close Signal shows green when opening and red when
closing. The Cam Control Command shows green when opening and red
when closing. The String Pot reads voltage.
8
Box Valves
Press ❽ to check computer actuation of hydraulic valves that control the
hopper width and hitch. Boxes light up when the function is actuated. Like
the switch diagnostic page checks the computer side of the function.
Engine
Press ❸ for Engine Functions and diagnostics.
Information
Press ❺ for help. Additional information and instructions
can be accessed by pressing the numbered button next to
the icon.
Defaults Page
Press ❻ for the Defaults Page.
The Set PSY Cal (Button ❹) will reset the PSY calibration
back to the initial factory setting. If you are having trouble
calibrating the PSY Correction because the rate is very far off
resetting to default may help.
Set All Defaults (Button ❽) will reset all factory defaults.
This not recommended and can cause grief. It is a factory
tool to help assemblers start from scratch.