Bearcat BC-2016/CRC, Instruction Manual

Page: 35 / 95

35
Displa
y
Hopper Setup Page
Press ❹ on the Settings Page to setup Hopper options.
Hopper Size Refers to the combined width of the front hoppers
WITHOUT extensions. This is an initial factory setting for the machine as
built. Press ❶ to highlight and use Up & Down buttons to correct and
OK to save.
LH & RH Extensions are for bolt on extensions that add width to the
main hopper. Press ❹ or ❽ to highlight the appropriate side and use
Up & Down buttons to correct and OK to save.
String Pots inform the computer of the hopper positions in regards to
width. The computer uses this information to calculate area covered
and disable unused gates in the center when tapering. A faulty hopper
string pot can cause the computer to think the hopper is narrower
than it is and shut off center gates. To disable the String Pots, press
❺ to highlight and press again to disable. This will disable the width
calculation and enable all gates regardless of width.