BCS 4206, Operating Manual

Page: 110 / 151

mi-4
Series 97
6.1 Fault and Warning Messages
When the printer detects a problem or the potential for a problem, a message is
displayed and the Error Indicator (see Section 4.0.4) will be illuminated. There
are two types of indications:
•
Fault Indication – the indicator ‘fast flashes’ with message.
•
Warning Indication – the indicator ‘slow flashes’ with message.
The Fault and Warning Messages are listed in the following two tables,
including a brief description of each and possible solution(s).
;
Note: After the printer enters a fault condition, the fault must be corrected
and then FEED key must be pressed to clear the condition.
Fault Messages:
Displayed Message Description Possible Solution(s)
""
The printer has
detected an analog
to digital circuit
converter failure. Try cycling the printer power
‘Off’ and ‘On’. If the fault
does not clear, call for
service.
"
The printer has
detected a cutter
mechanism fault. Try cycling the printer power
‘Off’ and ‘On’.
WARNING! Use extreme
care: Turn ‘Off’ and unplug
power before examining the
cutter.
Make sure the cutter option is
properly installed.
Carefully examine the cutter
for obstructions.
""
The printer has
detected a Direct
Memory Access
failure. Try cycling the printer power
‘Off’ and ‘On’. If the fault
does not clear, call for
service.
(Continued next page)