BAYKAL APH Series, User Manual

Page: 38 / 93

BAYKAL
EDITION NO : APH SECTION :
DATE OF ISSUE : July-2005 PAGE : 38
again, this controlled down-travel of the beam will continue. To
have the beam move up again at controlled speed, the
Right foot
or Up button should be pressed continuously. Releasing this foot
pedal, the beam travel will stop. The
″
stepping
″
mode is used
for tooling adjustments.
2- Turn the mode selector switch to the position 2 . When the left
foot switch is pressed, the beam will travel down in fast speed.
When the Beam touches slowdown switch, its velocity reduces.
Because the beam moves in slow speed you feed the sheet to the
machine anytime. The
pressure switch determines when the
down travel is stopped. After completion of the bending
operation, the beam will begin its upward travel in fast speed .If
the left foot switch is released at anytime, the beam will return at
fast speed until it is in contact with the top point switch.
3- Turn the mode selector switch to the position 2 in order to
perform bending operation. Top beam travel of the machine is in
two speeds. When the
Left pedal on the pedal control stand is
pressed continuously, the top beam will travel down in fast
speed, and will stop at the mute point. Before mute point, when
the pedal is released, the beam retracts immediately to the top
point. After the beam stops at mute point, feed the sheet to
machine in front of machine. Then, press the
Left Pedal again.
The beam will begin its downward movement in slow speed. The
pressure switch determines where the down travel is stopped.
After completion of the bending operation, the beam will begin
its upward travel in fast speed. When buttons are released after
mute point, the beam will stop.
Whenever you press the Right
Pedal, the beam will return at fast speed until it is in contact
with top point switch.
Figure 6.5.3.6