Baxi Senertec Dachs Pro 20 ST, Assembly And Operation Manual

Page: 67 / 118

14/4798.495.002 Installation | 67
Dachs Pro 20 ST
6.8 Oil supply connection
Note:
This chapter is not relevant for the Dachs Pro 20 ST.
The fuel supply is realised exclusively using natural gas.
i
Step 5
►
Connect the gas ball valve 6 to
the transfer point to the gas supply
prepared on site.
Step 6
►
Tighten the gas hose 5 stress-relieved
between the gas ball valve 6 and the
90° bracket 4 .
Fig. 60: Gas connection installation set
Vent the gas line:
Attention:
The gas hose including the internal gas duct may only be vented under supervision.
!
►
Open the gas valve and ensure gas supply to the Dachs Pro 20 ST.
►
Vent the gas line according to TRGI 8.1.1.1.3.
►
After venting, close the vent valve at the gas fitting.
►
Finally, check the tightness by means of leak spray or a leak detection device to check the entire gas duct.
Attention:
Check whether the venting valve connection is gas tight.
!
Reference:
Please observe the instructions and information in the iav Documentation
of VW on the EcoBlue 2.0 (Generation 1.2) in particular.