INSTALLER GUIDE
Page 31
14. OUTLET BAFFLE AND FASCIA FITTING
Before fitting the fascia ensure that the information on the back pages of the
owner guide have been completed.
14.1
Fitting the outlet baffle.
Locate the outlet baffle and secure in place
using two tapping screws supplied (See figure
29).
14.2
Fitting the fascia.
1.
At the upper right side of the fascia is a
blanking plate. Unscrew and remove the
blanking plate as it is not required.
2.
Supplied with the fire is a self adhesive
control position label. Peel the backing from
the label and place as in figure 30.
3.
Place the fascia against the fireplace front
surface so that the two retaining plates at the
back of the fascia are above the two upper
retaining brackets at the top of the convection
box. Lower the fascia making sure
that the rear retaining plates locate
fully into the retaining brackets on
the convection box (See figure 30).
If the inlet pipe runs along the front
of the fireplace, the bottom of the
fascia will have to be swung
forwards to clear the pipe while
lowering the casting.
©
Baxi Heating U.K. Limited 2010.
Figure 30. Fascia location (Fascia may differ
from that shown).
Figure 29. Outlet baffle.
