11. CERAMIC COALS INSTALLATION
This section is for models supplied with a ‘Coal’ fuel effect only.
For ‘Pebble fuel effect’ see section 12
The ceramic fuel effect may cause staining /
discolouration to decorative surfaces. It is therefore
advisable to protect decorative surfaces.
1.
Fit the ceramic coal into the fire above the burner. The
front of the ceramic coal should locate on the horizontal
faces but behind the vertical faces of the two location
brackets positioned at the front of the burner module. See
figure 15.
The coals should be positioned so that the arrows always
point towards the back of the firebox. When located into
position the stem of each arrow should be at 90° to the
rear of the firebox.
2.
Hold coal ‘A’ upright with
the arrow pointing to the top.
Locate coal ‘A’ as shown in
figure 16.
Page 25
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 16.
Figure 15. Ceramic coal
base location
