Baur PD-TaD 62, User Manual, Page: 37 / 114

PD-TaD 62 Connecting the system
822-187-3 37 / 114
No. Cable Step
On the VLF HV generator:
– –
If present, connect the external emergency off unit to the VLF HV generator
(
port).
If you are not using an external emergency off unit, ensure that a jumper
plug is inserted into the
port on the VLF HV generator.
3 Connection cable
C13
– C14G
Connect the VLF HV generator (mains supply) to the Power Box (port
depends on the connection cable).
On the laptop:
4 USB cable For the remote control of the VLF HV generator: Use a USB cable to
connect the laptop to the VLF HV generator.
5 Ethernet cable Use the supplied Ethernet cable to connect the laptop to the Power Box
(
Laptop port).
– –
If you do not want to run the laptop off its battery, connect the laptop to the
Power Box to establish a power supply. To do so, use the connection cable
with the C14G plug.
At the PD-TaD 62:
6 PoE cable Connect the PoE cable:

to the Power Box ( PD Detector port) and

to PD-TaD 62 ( Power Box port)
This is used for power supply and data transmission at the same time.
7
–
Connect the HF filter to the HV IN port.
Further information: Chapter Connecting the HF filter to the PD-TaD 62 (on
page 55)
8 HV connection cable of
the VLF HV generator
Connect the HV connection cable to the HF filter at the HV IN port.
Further information: Chapter Connecting the HF filter to the PD-TaD 62 (on
page 55)
9 Short-circuit cable of
PD-TaD 62 On the PD-TaD 62, remove the short-circuit cable from ports HV IN and
HV OUT .
At the far end of the test object:
10
–
Clean the cable termination of the phase to be tested carefully.
11
–
Attach the anti-corona hoods of the anti-corona protection device to the
cable termination of the phase to be tested.
At the near end of the test object:
12
–
Clean the cable termination of the phase to be tested carefully.
13
–
Attach the anti-corona hoods of the anti-corona protection device to the
cable termination of the phase to be tested.